



32m Alliance Concrete Boom Pump
- ACPA certified operator included
- WSIB clearance available
- Ontario owned since 1989
The unit Premier sends when the obstruction overhead, not the distance, is the problem. The five section ZZ fold opens in just 5.65 metres of headroom, so it works inside existing structures, under low power lines and beneath bridge decks, where a taller boom has nowhere to unfold. It still places concrete 31.4 metres up or 26.9 metres out, from a front footprint of 6.2 metres, and its unusually short rear outriggers make it adaptable on sites that would stop most pumps.
Other sizes in the fleet
The 32m is a compact boom pump, and compact is the whole point of it. Five sections on a ZZ fold give 31.4 metres of vertical range and 26.9 metres horizontally, which covers a nine or ten storey structure or a standard residential and light commercial pour comfortably. What sets it apart from the bigger units is not what it can reach, it is where it can stand.
Front outrigger spread is 6.2 metres and the rear only 4 metres. That short rear end is worth dwelling on, because it is unusual: most pumps spread wider at the back, so on a site where the constraint sits behind the truck this unit fits where its rivals do not. A 65m needs roughly 13 metres of clear ground each way; this works in about a third of that at the rear.
Unfolding height is 5.65 metres, and that is the number Premier actually sells this unit on. It opens in headroom that would stop a taller Z boom before it started, which puts three job types in range that nothing else in the fleet can take: pours inside existing structures with a roof or upper floor already on, sites where service wiring crosses the setup position, and bridge work where the boom has to reach in under the deck rather than over it. Beyond that it gets into laneways, closed sidewalks, courtyards and partly built structures that would otherwise need a line pump and a lot more hose.
Output is 164 m³/hr rod side, which is more than most jobs of this size can take delivery of. On a typical foundation or slab the ready-mix cycle, not the pump, sets the pace. Every booking includes an ACPA certified operator. Premier does not rent equipment without one.
Typical applications: urban infill foundations, townhouse and laneway builds, ICF walls, garage and basement slabs, footings, small commercial pads, and any site where the truck has to work from a road allowance or a single lane.
Figures below are taken from the Alliance JXZZ 32-5.16 manufacturer specification sheet, not from summary listings elsewhere on the site. Model designation JXZZ 32-5.16.
📏 Reach and Boom
| Vertical reach | 31.4 m (103′) |
| Horizontal reach | 26.9 m (88’3″) |
| Unfolding height | 5.65 m (18’6″) |
| Boom sections | 5 |
| Fold type | ZZ fold |
| Pipe diameter | 125 mm (5″) |
⚙️ Output and Pressure
| Output, rod side | 164 m³/hr (215 yd³/hr) |
| Output, piston side | 102 m³/hr (133 yd³/hr) |
| Pressure, rod side | 72 bar (1,044 psi) |
| Pressure, piston side | 115 bar (1,668 psi) |
| Strokes per minute | 31 |
| Stroke length | 2,100 mm (83″) |
🔧 Pump and Hydraulics
| Concrete cylinder | 230 mm (9″), hard chromed |
| S-tube size | 9″ x 7″ |
| Hopper capacity | 600 L, easy clean |
| Hydraulic pressure | 350 bar (5,076 psi) |
| Water tank | 500 L (132 gal) |
| Main oil pump | Rexroth Hydromatic A11VLO260 |
🚛 Outriggers and Chassis
| Front outrigger | X-style, 6.2 m (20’4″) spread |
| Rear outrigger | T-style, 4.0 m (13′) spread |
| Front outrigger extension | 7.25 m (23’9″) |
| Overall length | 10.38 m to 11.2 m, chassis dependent |
| Total weight | 22,800 to 24,950 kg (50,300 to 55,000 lbs) |
| Lube system | Automatic |
Piston side pressure of 115 bar is a system rating and is not to be used through boom pipe. Chassis figures cover both configurations Alliance supplies this unit on, so confirm the exact truck when you book if length or axle weight is critical. Need the full manufacturer document for a submittal package? Download the Alliance spec sheet PDF.
- ACPA certified operator. Every Premier operator is trained and certified to American Concrete Pumping Association standards. The unit does not go out without one.
- WSIB clearance certificate. Available on request for ICI and institutional prequalification packages.
- Daily equipment inspection. Completed before the unit leaves the yard, documented, and available if your safety officer asks.
- Lines, hoses and clamps for the configuration agreed at booking, including 2″, 3″, 4″ and 5″ line options.
- Pre-pour site walkthrough on commercial and institutional jobs. On tight access work this is worth taking up, because setup position on a constrained site is not something to settle on pour morning.
- Unionized labour standards and OHSA compliance, as required on most commercial ICI sites.
Fuel, washout facilities and site access are the contractor’s responsibility unless agreed otherwise in writing at booking.
This is the unit you book because access is tight, so the access questions matter more here than on any other pump in the fleet. Work these through before you book.
- Outrigger spread. 6.2 m across the front and 4 m at the rear, with the front outriggers extending 7.25 m when measured across the full extension. Allow a clear working area of roughly 7.5 m at the front of the truck. That is about half what a large boom needs, which is usually the reason this unit gets specified.
- Ground bearing. Total weight is 22,800 to 24,950 kg depending on chassis, concentrated through the outrigger pads. Fresh backfill, buried services, basement slabs and septic beds all need review first. Cribbing or pads may be required.
- Overall length. 10.38 m to 11.2 m of truck depending on the chassis, before outriggers. Check gate widths, turning circles and any switchback in the access route.
- Overhead clearance. The boom needs 5.65 m of unfolding height, which is low enough to open under most canopies and beside existing structures. Power lines inside the working radius still have to be identified in advance. Premier will not set up under live lines.
- Road allowance and permits. On downtown work the truck often stands on a closed lane or sidewalk. Lane occupancy permits are the contractor’s responsibility, and they take longer to obtain than the pump takes to book.
- Washout. A washout location must be nominated before the pour. Premier does not wash out to grade or to drains.
- Rail corridors. Premier runs range limiting systems, so pours adjacent to rail are possible. Flag it at booking, it changes the setup.
If the site still will not take a truck this size, the trailer and line pumps reach the same places through line, and basement and confined space pumping covers how those jobs are usually run.
Is the 32m Alliance the Right Pump for Your Pour?
Specify this unit when
- Urban infill and downtown sites where the truck has to work from a lane or a closed sidewalk
- Townhouse blocks, laneway builds and subdivisions with houses already standing either side
- Working inside existing structures, where the boom has to open and operate beneath a roof or an upper floor already in place
- Bridge and infrastructure work needing the boom to reach under a deck rather than over the top of it
- Pours under a canopy, a soffit or an adjacent structure, where there is no room to unfold a taller boom
- Sites with low power lines crossing the setup position
- Residential foundations, footings, ICF walls and garage slabs on lots that cannot take a larger truck
- Feeding through a window or door opening into a partly enclosed building
Use a different unit when
- Anything above roughly nine or ten storeys. Vertical reach stops at 31.4 m, so a 43m, 47m or larger is the answer
- Large commercial slabs where 26.9 m of horizontal reach would mean three setups instead of one
- Pours where the ready-mix truck cannot get within about 25 metres of the placement point
- Fully enclosed, basement or low-clearance work with no boom access at all. Use the TK 1005 trailer pump, which pushes 300 m and beyond through line
- Stone, gravel or fill placement. That is a telebelt job
How It Compares to the Units Either Side
| Unit | Vertical | Horizontal | Best for |
|---|---|---|---|
| 31m Putzmeister ZX | 31 m | 27 m | Urban confined pours, the most restricted access in the fleet |
| 32m Alliance ZZ (this unit) | 31.4 m | 26.9 m | Tight urban lots and low headroom, 5.65 m to unfold |
| 36m Putzmeister Z | 36 m | 32 m | Residential slabs, foundations and flatwork with normal access |
The 31m and the 32m sit close together on reach, so the choice between them is usually decided by the site rather than the numbers. Send us the access and we will tell you which one goes. Above this, the 38m through 65m units trade setup footprint for height and carry.
Where the 32m Earns Its Place
This unit spends most of its life on sites that other pumps cannot get into. Downtown Toronto office fit-outs where the concrete has to go through a window opening on the second or third floor. Townhouse blocks part way through construction, where the laneway between two finished rows is the only place a truck can stand. Backyard pours reached over the roof of the house rather than around it.
The pattern is always the same: the volume is manageable and the height is modest, but the setup footprint decides whether the job can be pumped at all. If you are not sure which size your site will take, our guide to how far a boom pump can reach and which size to rent walks through the sizing maths, and how to prep your site for concrete pumping covers what has to be sorted before the truck arrives. On sites where even this unit is too much truck, the trailer and line pumps get there through line instead.
Frequently Asked Questions, 32m Alliance
How high can the 32m actually pump?
31.4 metres vertically, measured from ground level at the truck, and 26.9 metres horizontally from the boom pedestal. That covers roughly nine to ten storeys from a single setup, or any standard residential and light commercial pour. The fleet listing rounds these to 32 m and 28 m; the figures here come from the Alliance spec sheet.
How much space does it need to set up?
Allow about 7.5 metres of clear working area across the front of the truck and 4 metres at the rear. Front outrigger spread is 6.2 m and rear is 4 m. The truck itself is 10.38 m to 11.2 m long depending on chassis, before outriggers. That is roughly half the footprint of a large boom, which is normally why this unit gets picked.
Can it set up under a canopy or beside an existing building?
Usually yes. The ZZ fold needs 5.65 metres of unfolding height, which is low enough to open under most canopies, soffits and first floor overhangs. A taller Z boom needs far more room to swing open. Send a photo of the setup position and we will confirm before you commit to a pour date.
Can it work under a bridge deck or inside an existing structure?
Yes, and those are two of the jobs it is specifically kept for. The 5.65 metre unfolding height means the boom can open beneath a deck or under a roof that is already on, and place from there. Send us the clear height at the setup position and the distance to the pour, and we will confirm whether the boom has room to work rather than just room to open.
Is an operator included in the rental?
Yes. Every Premier unit goes out with an ACPA certified operator. Premier does not rent pumps as equipment only. The operator coordinates with your forming crew and handles setup, placement and washout.
What placement rate can I schedule against?
The pump is rated at 164 m³/hr rod side and 102 m³/hr piston side. On jobs this unit suits, the real limit is almost always how fast the ready-mix trucks cycle rather than the pump. Tell us your volume and access and we will give you a realistic figure to build the schedule on.
Do I need the 32m, or would a different unit be better?
Book the 32m when the constraint is where the truck can stand, not how far the boom has to go. If you need more than nine or ten storeys of height, or the placement point is more than about 25 metres from the road, a 38m to 47m unit is the better call. If there is no boom access at all, a trailer pump running line is. Give us the storey count, the distance and the access and we will tell you honestly which one fits.
Popular Equipment
The units Ontario contractors book most often, alongside this one.

Larger Boom Pumps
When 31.4 m is not enough height or 26.9 m not enough carry. 38m through 65m units, all with operators.

Trailer and Line Pumps
For basements, indoor pours and sites with no boom access at all. Pushes 300 m and beyond through line.

Telebelt Conveyor
Concrete, stone, gravel and fill to about 130 ft, with no pipe and no clogging. One unit, so book early.
Check Availability for the 32m
Send us the pour date, the volume and a photo or plan of the access, and we will confirm whether the 32m fits, or point you at a unit that does. No obligation.