← Back   Our Equipment » Boom Pumps » 43m Alliance Concrete Boom Pump

43m Alliance Concrete Boom Pump

Alliance JXRZ 43-5.16 | 5 section RZ roll and fold | 8.8 m unfolding height

The most generally useful boom in the fleet, and the one Premier reaches for when a job could go either way. 42.5 metres up, 38.5 metres out, on a five section RZ boom that rolls open rather than swinging through a single arc. That combination covers residential wall pours, large slabs, roof pads and light commercial work without either running short of reach or bringing more truck than the site can take.

42.5 m vertical reach
Typically on site within 24 to 48 hours of booking
Or call 519-942-3410  |  Toll free 1-866-942-3410

Other sizes in the fleet

If Premier could only keep one boom pump, there is a good argument it would be this one. 42.5 metres of vertical reach and 38.5 horizontally is enough for the large majority of Ontario work that is not a tower, and the truck is still small enough to get onto an ordinary site.

The boom is a five section RZ, which rolls open in stages rather than unfolding in one sweep. Two things follow from that. It needs only 8.8 metres of headroom to deploy, low for a boom this size, so overhead wires and adjacent structures rule it out far less often than you would expect. And with five sections it articulates properly, so the boom can be dropped into an excavation and worked along a wall rather than simply pointed at the pour.

Output is 164 m³/hr rod side. On a large slab that is enough to keep a finishing crew moving, and on most jobs the ready-mix cycle is the binding constraint rather than the pump. Every booking includes an ACPA certified operator. Premier does not rent equipment without one.

Typical applications: residential and commercial wall pours, deep foundations, large slabs and roof pads, ICF programs, low-rise commercial and institutional structures, mid-size industrial pads.

Figures below are taken from the Alliance JXRZ 43-5.16 manufacturer specification sheet, not from summary listings elsewhere on the site. Model designation JXRZ 43-5.16.

📏 Reach and Boom

Vertical reach42.5 m (139’5″)
Horizontal reach38.5 m (126’4″)
Unfolding height8.8 m (28’10”)
Boom sections5
Fold typeRZ roll and fold
Pipe diameter125 mm (5″)

⚙️ Output and Pressure

Output, rod side164 m³/hr (215 yd³/hr)
Output, piston side102 m³/hr (133 yd³/hr)
Pressure, rod side72 bar (1,044 psi)
Pressure, piston side115 bar (1,668 psi)
Strokes per minute31
Stroke length2,100 mm (83″)

🔧 Pump and Hydraulics

Concrete cylinder230 mm (9″), hard chromed
S-tube size9″ x 7″
Hopper capacity600 L, easy clean
Hydraulic pressure350 bar (5,076 psi)
Water tank800 L (211 gal)
Main oil pumpRexroth Hydromatic A11VLO260

🚛 Outriggers and Chassis

Outrigger styleX-style
Front spread7.6 m (24’11”)
Rear spread8.8 m (28’10”)
Boom section lengths8.4 / 7.0 / 6.9 / 7.9 / 8.3 m
Overall length12.0 m to 12.9 m, chassis dependent
Total weight31,160 to 31,620 kg (68,700 to 69,700 lbs)

Piston side pressure of 115 bar is a system rating and is not to be used through boom pipe. Alliance supplies this unit on two chassis, so length and axle weights vary; confirm the exact truck at booking if either is critical. Need the full manufacturer document for a submittal package? Download the Alliance spec sheet PDF.

  • ACPA certified operator. Every Premier operator is trained and certified to American Concrete Pumping Association standards. The unit does not go out without one.
  • WSIB clearance certificate. Available on request for ICI and institutional prequalification packages.
  • Daily equipment inspection. Completed before the unit leaves the yard, documented, and available if your safety officer asks.
  • Lines, hoses and clamps for the configuration agreed at booking, including 2″, 3″, 4″ and 5″ line options.
  • Pre-pour site walkthrough on commercial and institutional jobs, so setup position, outrigger bearing and washout are settled before pour day rather than on it.
  • Backup equipment access. On large multi-day pours Premier can stage a second unit. Worth arranging at booking, not on the morning.
  • Unionized labour standards and OHSA compliance, as required on most commercial ICI sites.

Fuel, washout facilities and site access are the contractor’s responsibility unless agreed otherwise in writing at booking.

A mid-to-large boom, so the site questions matter. Work these through before you book rather than on pour morning.

  • Outrigger spread. 7.6 m across the front and 8.8 m at the rear. The rear is the wider end on this unit, so the constraint is usually behind the truck, not in front of it. Allow a clear area of roughly 9 m each way.
  • Ground bearing. 31,160 to 31,620 kg depending on chassis, concentrated through four pads. This is where the 43m starts to need thinking about: fresh backfill, basement slabs, buried services and septic beds all need review beforehand, and cribbing is common.
  • Overall length. 12.0 m to 12.9 m of truck before outriggers. Check gate widths, turning circles and any switchback on the access road.
  • Overhead clearance. 8.8 m of unfolding height, which is low for this reach and one of the reasons the unit gets specified. Power lines inside the working radius still have to be identified in advance. Premier will not set up under live lines.
  • Washout. A washout location must be nominated before the pour. Premier does not wash out to grade or to drains.
  • Rail corridors. Premier runs range limiting systems, so pours adjacent to rail are possible. Flag it at booking, it changes the setup.

If the ground or the footprint will not take a unit this size, the 38m is lighter and needs less room. Our guide to pump setup on complex sites covers the harder cases.

Is the 43m Alliance the Right Pump for Your Pour?

Specify this unit when

  • Residential wall pours and deep foundations where the boom has to drop into the excavation and place lift by lift
  • Large slabs and roof pads that a 38m would need two setups to cover
  • Light commercial and institutional work up to roughly thirteen storeys
  • Sites that are snug but not genuinely tight, where the RZ fold gets the boom open in 8.8 m of headroom
  • ICF programs where controlled pour rate matters and the walls are spread across the footprint

Use a different unit when

  • Tight urban infill. You need roughly 9 metres of clear outrigger spread at the rear. The 32m ZZ works in about half that
  • Standard house foundations on open lots. A 38m does that job for less money and sets up faster
  • High-rise cores, or any carry beyond 38 metres. Step up to the 50m or the 65m
  • Basement, indoor or low-clearance pours with no boom access. Use the trailer and line pumps
  • Stone, gravel or fill placement. That is a telebelt job

How It Compares to the Units Either Side

UnitVerticalHorizontalBest for
38m 4-section Alliance37.1 m33.1 mStandard foundations and mid-size pours, quickest setup
43m Alliance RZ (this unit)42.5 m38.5 mLarge slabs, wall pours and roof pads from one setup
50m Alliance RZ49.3 m44.4 mCommercial and mid-rise, longer carry from the road

The step from 38 to 43 metres buys about 5 metres of carry for roughly 6 tonnes more truck. The step from 43 to 50 buys another 6 metres for another 20 tonnes. If the 43m reaches, it is almost always the more economical answer.

Where the 43m Earns Its Place

This unit lands in the middle of the fleet on purpose. A great deal of Ontario work is too big for a 38 metre boom and nowhere near big enough to justify a 50 or a 65: a large residential slab, a roof pad on a low-rise, a deep foundation on a sloped lot, a mid-size commercial pad with the ready-mix stuck out on the road. The 43m covers all of that from one setup.

The RZ boom is the other half of it. Roll and fold sections open in 8.8 metres of headroom, which for a boom of this reach is low, so the unit gets into places a Z boom of the same size could not open in. If you are weighing this against the sizes either side, our guide to how far a boom pump can reach and which size to rent covers the sizing maths, and choosing a pump size for a commercial project works through it from the estimator’s side. For ICF programs, how Premier runs ICF pours explains the pour rate control.

Frequently Asked Questions, 43m Alliance

42.5 metres vertically from ground level at the truck, and 38.5 metres horizontally from the boom pedestal. That is roughly thirteen storeys from a single ground level setup, or a large slab covered without repositioning.

Allow a clear area of about 9 metres each way. Outrigger spread is 7.6 m at the front and 8.8 m at the rear, so the rear is the wider end and usually the binding constraint. The truck is 12.0 m to 12.9 m long before outriggers, and total weight is 31,160 to 31,620 kg depending on chassis.

Two reasons. Reach, if the placement point is more than about 33 metres from where the truck can stand, or the structure is above eleven storeys. And articulation, because five RZ sections drop into an excavation and work along a wall in a way a four section boom cannot. If neither applies, the 38m is the cheaper and faster call and we will tell you so.

It needs 8.8 metres of unfolding height, which is genuinely low for a boom of this reach, so it opens in places a comparable Z boom cannot. That said, Premier will not set up under live lines, and lines inside the working radius have to be identified before pour day. Send a photo of the setup position and we will confirm.

Yes. Every Premier unit goes out with an ACPA certified operator. Premier does not rent pumps as equipment only. The operator coordinates with your forming crew and handles setup, placement and washout.

164 m³/hr rod side and 102 m³/hr piston side. Real world rate depends on your mix, line configuration and how quickly the ready-mix trucks cycle. On a large slab the finishing crew and the truck cycle usually set the pace, not the pump. Give us your volume and we will give you a figure to build the schedule on.

Popular Equipment

The units Ontario contractors book most often, alongside this one.

Premier Concrete Pumping 38m Alliance boom pump, unit 210, folded on a Mack chassis in the yard on a snowy morning

38m Boom Pumps

Four and five section 38 metre units for standard foundations and mid-size pours on tighter budgets.

50m concrete pump

50m Alliance RZ

Nearly seven more metres up and six more out, when the 43m comes up short on a commercial pour.

Putzmeister Tow Behind Trailer Pump

Trailer and Line Pumps

For basements, indoor pours and sites with no boom access at all. Reaches through line instead of over the top.

Check Availability for the 43m

Tell us the pour date, the volume and how far the placement point sits from where the truck can stand. We will confirm whether the 43m is the right call. No obligation.

Need help selecting the right boom pump for your project?